Pin-shaped terminal for "V-connection" of surge arresters up to 25 mm2, suitable for DEHNshield, DEHNguard M, DEHNguard S and DK 25 feed-through terminals.
Earthing pipe clamp for integrating pipes into the protective and functional equipotential bonding according to IEC 60364-4-41/60364-5-54 (DIN VDE 0100-410/540). Type Standard, with continuously ad...
Two spring terminals for the protected and unprotected side of a BLITZDUCTOR SP / XT / XTU arrester for permanent low-impedance shield contact with a shielded signal line. Insulating cap for indire...
Multipurpose connecting clamp according to EN 62561-1, for universal use as a cross clamp, T clamp, and parallel clamp for round conductors. Two-piece with hexagon screw and thread in the base part.
Snap-on earthing frame for earthing and installation of max. 10 DRL protective plugs. Plugs into a 10-pair disconnection block or DRL plug-in SPD block.
Concrete bases for air-termination rods Rd 10 mm (length 1000 mm) for protecting small roof-mounted structures on flat roofs and for installing spacers, e.g. for isolated ring conductors with DEHNi...
Earthing module for BLITZDUCTOR SP / XT. The plugged-in module connects all lines connected to the BLITZDUCTOR XT base part to the equipotential bonding. It directly earths unused cable cores, whic...
BLITZDUCTOR XT base part for use as very space-saving and universal four-pole feed-through terminal for intrinsically safe circuits for the insertion of SPD modules, no signal interruption if the p...
Protective plug (one pair), energy-coordinated with DRL plug-in SPD block, for use as single-stage protective device for terminal equipment. Low voltage protection level line-line and integrated ov...
Single-pole DEHNguard S surge arrester (type 2 according to EN 61643-11) consisting of a base part and plug-in protection module. High reliability due to Thermo Dynamic Control SPD monitoring devic...
Certain installation instructions have to be observed when using BLITZDUCTOR XT Ex (i) surge protective devices in intrinsically safe circuits.In accordance with EN 60079-11;2007 a minimum distance...
Protective plug (one pair), energy-coordinated with DRL plug-in SPD block, for use as single-stage protective device for terminal equipment. Low voltage protection level line-line for floating inte...
The set comprises a DIN rail for up to 24 DEHNpatch devices and different distance bolts with sliding nuts for installation into data distributors. To save space, the DIN rail can be mounted at the...
Protective plug (one pair), energy-coordinated with DRL plug-in SPD block, for use as single-stage protective device for terminal equipment for high-frequency transmissions such as G.703 or ISDN U2...
The BLITZDUCTOR SP base part is a very space-saving and universal four-pole feed-through terminal for the insertion of a protection module, signal interruption if the protection module is removed. ...
Lightning current arrester with F socket for remote supply for 75 ohm satellite and broadband cable systems. It fulfils the high shielding requirements of class A according to EN 50083-2. It allows...
Multipole DEHNguard M surge arrester (type 2 according to EN 61643-11) consisting of a base part and plug-in protection modules. High reliability due to Thermo Dynamic Control SPD monitoring device...
Multipole DEHNguard M surge arrester (type 2 according to EN 61643-11) consisting of a base part and plug-in protection modules. High reliability due to Thermo Dynamic Control SPD monitoring device...
Three-pole DEHNcord R type 2 surge arrester according to EN 61643-11 with a compact design for use in flush-type boxes, flush-mounted systems and cable ducts. For protecting low-voltage consumer's ...
Two-pole DEHNrail modular surge arrester (type 3 according to EN 61643-1) consisting of a base part and plug-in protection module. High discharge capacity due to heavy-duty zinc oxide varistor / sp...
Space-saving combined arrester module for protecting one pair of unearthed balanced interfaces. Module is adapted to the controller of motor-driven actuators with starting and operating currents up...
Two-pole DEHNflex surge arrester (type 3 according to EN 61643-11) with monitoring device and disconnector. Enhanced safety du to Y protective circuit. For protecting electronic equipment against s...
Surge arrester with F socket for remote supply for 75-ohm satellite and broadband cable systems. It fulfils the high shielding requirements of class A according to EN 50083-2. It allows space-savin...
Multipole DEHNguard M surge arrester (type 2 according to EN 61643-11) consisting of a base part and plug-in protection modules. High reliability due to "Thermo Dynamic Control" SPD monitoring devi...